Freedom Series Rear Oval Overlays - 2021+ Bronco

Product information from StickerFab

Manufacturer warranty and guarantee statements below are subject to that manufacturer’s terms. For return eligibility through Lee Mods, see Returns & Exchanges. Ask Lee Mods to clarify any warranty or guarantee before ordering.

• Various flag designs
• Easy to apply
• Installation video below

2021+ Bronco Freedom Series Rear Oval Overlays

Here's a new series of rear overlay overlays for your 2021+ Bronco.  We have an assortment of flag designs so you can show off you whatever you stand for and / or take pride in.

Currently fits ALL 2021+ Broncos.  Matte finish.  Sold as a pair (one backup)

NOTE:  This only goes OVER your OEM emblem.  You must have an OEM emblem in good condition to install this. 

Features

• TruProtect - UV Resistant Laminate
• TruPrint - Authentic Roland inks and printers
• Made in the USA

Customization

While StickerFab caters to a large number of people, it is still possible to customize some orders.  Ideas that have broad appeal are the best!  However, if you have some art work, we may be able to do a special print just for you.

• Military Themed
• Patriotic
• Other organizations

Please refrain from submitting trademarked content unless you have the rights to it.  We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.

Use our contact form to get in touch with us.

Instructions

Items you may want to have:

• Detail Spray (without wax)
• Microfiber Towel or Paper Towel
• Dish with soapy water (drop of dish soap + 1-2 cups of water)
• StickerFab Application Fluid preferred
• Heat gun or hair dryer

Ideal installation temperature (weather) is 75-85 degrees.  Do the install in the shade unless it is cooler than 75.

Clean the application area to prepare it for installation.  Do not use a spray with any type of wax in it.

A wet installation is recommended for very novice customers.  Use slightly soapy water on the back of the vinyl.  This will allow you to move the vinyl around and find the correct alignment.  Once aligned, use your fingers to push out the water/air.  Use light heat as needed to make sure that the overlay does not crease and adheres properly to the OEM emblem.