Ford Bronco FS-15 Series Rear Bumper

The FS-15 Series Bronco Rear Bumper was designed to maximize ground clearance and provide superior rear-end protection.. The license plate mount is located above the bumper and includes an LED plate light. Up to a 37-inch spare tire will fit above the bumper. Two 3-inch flush mount pod lights can be installed towards either side of the bumper. Two reinforced clevis mounts that take -inch D-ring shackles provide recovery options in case you get into trouble on the trail. This bumper is constructed of 3.5mm steel plating with 5mm steel supports, and then finished in a finely textured black powder coat to protect against rust.

• Higher Than Factory Ground Clearance
• 3.5mm Steel Plates With 5mm Steel Supports
• Micro Texture Black Powder Coat
• Accepts Two, 3 Flush Mount Led Pod Lights
• Dual Clevis Mounts For D-Ring Shackles
• Retains Factory Backup Sensors
• Accommodates Up To 37" Spare Tire

Specifications

• Installation Level - 1 = Easy, 5 = Hard: 3
• Installation Time (hrs): 2.5 Hours
• Product Material: Steel
• Product Texture: Micro-Texture Black Powder Coat
• Prop 65 Warning Required (Y/N): YES
• Prop 65 Warning Verbiage: WARNING: This product can expose you to chemicals including lead and lead compounds, DEHP and bisphenol A (BPA) which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Vehicle application overview

Confirm trim, engine, and installation requirements before ordering.

• 2021–2026 Ford Bronco