Matte Window Frame Black Out Kit - 2025+ 4Runner

• 4 piece set
• Blacks out the remainder of the window frame (sides)
• Install video below

2025+ Toyota 4Runner Matte Window Frame Black Out Kit

This 4 piece vinyl kit let's you black out the rest of the window frame (A pillar area) on your 6th generation 4Runner.  It can also provide added paint protection.

Please watch our video in the installation section for tips.  

4 pieces:

• Driver Window Frame Piece
• Driver Frame Extension Piece
• Passenger Window Frame Piece
• Passenger Frame Extension Piece
  

Recommended items:

• This Kit
• StickerFab Installation Fluid (1 bottle)
• Squegee (1 ours or your own)
• Microfiber
• Detailer spray to prep the area (without wax)
• Heat gun or hair dryer

The fluid, squeegee, and microfiber can also be purchased as a kit here.

NOTE:  2 sets are sold at a reduced price.  Keep it as a backup or in case your first install proves to be difficult.

INSTALLATION

We recommend doing this after a fresh car wash.  Re-clean the application area to prepare it for installation.  Just use a wax free detailing spray if your vehicle is not too dirty.  Do not forget to clean the edges of the A pillar.  Also wash your hands.  You do not want to get dirt stuck to the adhesive side of the material.

NOTES:  We recommend that the installation area be free of wax and not under direct sunlight.  Use of a hair dryer or heat gun (low amounts of heat) may be needed for the outer portions if it is not stretching / drying at a desirable rate.  Use sparingly.

You will want to do this in 74-84 degree weather ideally.  Stay in the shade. 

Apply application fluid to the target install and nearby surrounding area.  Also apply it to the back of the material as it is removed from the backing paper.  Apply it to your fingers for bonus points.

With a liberal amount of application fluid on the target area and material , you can change the alignment of the material by gently pulling up on portions and setting it back down.

Once you alignment is ideal, you can start to squeegee out the liquid.  Our video has key tips on this such as aligning the inside edge and starting at the bottom.

Try to get out all bubbles without damaging the material.  Take your time and learn how the material reacts to pressure.