Fabtech K7106DL 3-Inch Ball Joint UCA Lift Kit with Reservoir Dirt Logic Shocks — 2024 Tacoma 4WD

Fabtech K7106DL combines ball-joint upper control arms, front Dirt Logic 2.5 reservoir coilovers, rear coil spacers and rear Dirt Logic 2.25 reservoir shocks for the specified Tacoma configuration.

Application

• 2024 Toyota Tacoma SR5, TRD Sport or TRD Off-Road, 4WD, with factory rear COIL springs. Verify the actual trim, rear suspension and installed equipment before ordering.
• Excludes TRD Pro, Trailhunter, Adaptive Variable Suspension (AVS), rear leaf springs and 2WD. Limited, SR, TRD PreRunner, 2025–2026 Tacoma and 4Runner applications are outside this listing.

Package contents

• One FTS26123 ball-joint upper control-arm kit: driver and passenger arm pair with the specified bushings, sleeves, washers, ball-joint spacers, caps and mounting supplies.
• One FTS26125 rear coil-spacer kit: TWO rear coil spacers, one driver and one passenger bumpstop extension and specified hardware. The factory rear coil springs are retained.
• One FTS26126 FRONT Dirt Logic 2.5 reservoir-coilover PAIR: one driver and one passenger assembly, two upper mounts, two reservoir mounts and specified misalignments, clamps and hardware.
• TWO individually packaged FTS80172 REAR Dirt Logic 2.25 reservoir shocks, with the specified reservoir mounts and bushing/hardware kits. FOUR new dampers total; both front and rear pairs have remote reservoirs.

Installation and requirements

• Professional installation required. Read FT26123i, FT26125i, the FTS26126/FT82086i front-coilover instructions and FT80172i rear-shock instructions before work. Verify all supplied parts and factory alignment.
• Front-arm clearance requires cutting the specified section of the rear coil-bucket lip on each side. The front-coilover procedure requires radius sanding of the lower strut mount and 17/64-inch pre-drilled reservoir-bracket holes. Use the correct upper-mount notch orientation and lower misalignments.
• The rear procedure requires drilling the three original upper coil-mount holes on each side to 7/16 inch and cutting the factory bumpstop brackets for the supplied extensions. Retain the factory rear springs and reconnect the rear sway bar if equipped.
• Install the specified lower rear-shock spacer first, and secure each rear reservoir to the frame with its supplied mount, self-tapping bolts and clamps. Keep pressurized shock hoses and tamper caps sealed.
• Follow the complete kit procedures, check all line and tire clearances, align to factory specifications, adjust headlights and recheck fasteners after 50 miles and periodically. Nominal system lift is not a claim of equal added height at every axle.

Tire and wheel guidance

• Manufacturer guidance: 33/12.50R18 on 18×9 wheels or 33/12.50R20 on 20×9 wheels, with 4-1/2-inch backspacing and minor trimming. Verify actual clearance; wheels and tires are sold separately.

Manufacturer part number: K7106DL. Manufacturer product details.

California Proposition 65: WARNING: Cancer and Reproductive Harm. www.P65Warnings.ca.gov.