Fabtech K7114DL 3-Inch Lift Kit with Front & Rear Dirt Logic Reservoir Shocks — 2025 4Runner TRD Sport 4WD

Fabtech K7114DL supplies a complete matched suspension system with ball-joint upper control arms, front Dirt Logic reservoir coilovers, rear Dirt Logic reservoir shocks, differential-drop brackets and rear coil spacers.

Application

• 2025 Toyota 4Runner TRD Sport, 4WD, non-hybrid, with factory rear coil springs and without Adaptive Variable Suspension (AVS). Confirm the exact trim, drivetrain, rear springs and installed equipment before ordering.
• This listing covers the TRD Sport configuration only. SR5, TRD Sport Premium, TRD Off-Road and Premium, Limited, Platinum, TRD Pro, Trailhunter, hybrid, RWD and all other years are outside this listing.
• Nominal 3-inch system. One complete K7114DL system is supplied; factory rear coil springs are retained.

Package contents

• One FTS26123 ball-joint upper control-arm kit containing the driver/passenger arm pair and specified bushings, sleeves, washers, caps, ABS-line clamps and hardware.
• One FTS26131 differential-drop kit with driver, passenger and rear brackets, six bushings, three sleeves and specified installation hardware.
• One FTS26135 rear coil-spacer kit: two coil spacers, driver/passenger rear bumpstop extensions, two bumpstop spacers and specified hardware.
• One FTS26137 front Dirt Logic 2.5 reservoir-coilover PAIR: driver FT82087D and passenger FT82087P, two upper mounts, two reservoir brackets, specified upper/inner-lower/outer-lower misalignments, clamps and hardware.
• Two FTS80173 rear Dirt Logic 2.25 remote-reservoir shocks. FOUR new dampers total, with remote reservoirs on both the front and rear pairs. The Sport kit front strut/preload spacers are not part of this system.

Installation and requirements

• Professional installation required. Inspect the complete matched system and factory suspension, record alignment, and read all supplied component instructions before work.
• Install the front upper mounts with their locating notches toward the outside; fit the correct inner and outer lower misalignments, with the larger lower misalignment outward. Keep the factory-set coils and reservoir hoses assembled.
• The front reservoir brackets require 17/64-inch pre-drilled frame holes for the supplied self-tapping fasteners and clamps. Route and secure all reservoir hoses clear of tires and suspension travel.
• Support and reposition the front differential using all three supplied brackets and specified hardware. Install the ball-joint arms with the required bushings, sleeves, washers, caps and ABS-line clamps.
• The linked upper-arm guide specifies a coil-bucket lip clearance cut. Follow the exact supplied kit procedure and locations.
• The rear guide requires drilling the three upper coil-mount holes on each side to 7/16 inch and cutting the specified rear bumpstop brackets. Install the spacers with the factory coil springs and isolators, then the rear reservoir shocks using their supplied instructions.
• Check hose, wire, tire and suspension clearances through full steering and suspension travel. Align to factory specifications, adjust headlights and recheck fasteners after 50 miles and periodically.

Tire and wheel guidance

• Manufacturer guidance: up to 285/70R17 tires. Actual clearance depends on the wheel and vehicle configuration; check before installation. Wheels and tires are sold separately.

Manufacturer part number: K7114DL. Manufacturer product details.

California Proposition 65: WARNING: Cancer and Reproductive Harm. www.P65Warnings.ca.gov.